Checking the Variac with the Oscilloscope

Started on a little more of the wiring today. My task was to add a feed wire from the variac unit which would supply 240v to the SRSG feed transformer. This wire would just tap into the input feed after the on/off switch within the variac housing. I thought it would be a good idea to test the variac electrical connections before adding anymore wiring. The safest way to do this was to use the function generator on my oscilloscope to supply a low amplitude (about 5v) 50Hz signal across the input terminals of the variac and test the output with one of the channels on the oscilloscope.

Here's the setup I used. The function generator is plugged into the inputs of the variac and also channel 2 of the oscilloscope. The oscilloscope probe is connected across the output of the variac and feed into channel 1 on the oscilloscope. With both channels set to the same volts/div and the scope set to dual trace (shows both channel traces on same screen) it's very easy to see to compare input and output of the variac. Far safer than slapping a plug on the variac, plugging into the mains and hoping all is OK.

You can see from the video when the variac control knob is set to zero there is no output. As the knob is rotated the flat trace rises till it reaches the same amplitude as the output of the function generator. This is the required result and shows that the variac is functioning correctly. When in use with the tesla coil I will only need to use about half the range of the variac as the NST is rated at 110v. Tomorrow I will add the wiring for the SRSG. 

1. +1 my blog and email it to a friend.

2. Follow me.... It's good to know someones interested.

3. Leave a comment.... All are appreciated.

Spinning up the Spark Gap Motor

Finished the last bit of wiring on the synchronous motor and the step down transformer supplying it. Annoyingly the little ceramic 3 pole terminal block cracked when re-mounting it, on closer inspection it really is a horribly made piece of crap from B+Q. I have ordered a similar looking unit from eBay tonight, hopefully it's better quality and will fit the mount holes already drilled, if not I may create my own from a block of perspex. Anyway time to plug in the the spark gap module. Fingers crossed.

Well that went pretty well. The spark gap disc seems to be well balanced and the motor is very quiet, not that that will make any difference once the gaps are firing. The motor took more than 40 seconds to come to a complete rest after unplugging. There is a fair bit of weight involved in the spark gap disc but I still think this is a good indication to the quality of the bearings in this little motor.

Hers's a close-up of the cracked terminal block. I had to remove it when I was wiring in the cable in the pic as I had trouble tightening the cable clamp screws. When I checked the screw heads non of the slots were formed correctly. I used the 2 best formed clamp screws to secure the new wiring and refitted the block, this is when it cracked. Two steps forward, one step back.


1. +1 my blog and email it to a friend.
2. Follow me.... It's good to know someones interested.
3. Leave a comment.... All are appreciated.